|
Hi Jeff,
No... that's not what I mean (nor what Tim meant)
1. Switch off
2. Hold down Eject button and turn on
But, Dominik's advice to check the ribbon cable first sounds
good.
Regards,
Tone :)
At 12:33 29/07/2005, you wrote:
It's
all the buttons on the front panel. I can switch the inputs from
SDI to componant though
- ----- Original Message -----
- From: Tony Quinsee-Jover
- To: DS(at)Softimage.COM
- Sent: Friday, July 29, 2005 7:18 AM
- Subject: RE: Help Digital Betacam DVWA500 frozen OT
- Ahh... it's the Eject button, not the Stop button...
- T :)
- At 12:11 29/07/2005, you wrote:
- You have probably tried
this but if not.
-
- Rewind the tape.
-
- Powercycle the VTR and hold the eject button on power up.
-
- Good luck
-
- Tim
-
- From:
owner-ds(at)Softimage.COM [
mailto:owner-ds(at)Softimage.COM] On Behalf Of Jeff Krebs
- Sent: 29 July 2005 12:02
- To: DS(at)Softimage.COM
- Subject: Help Digiital Betacam DVWA500 frozen OT
-
- Help on this OT
-
- Digitizing from a betasp tape inside my
DVWA500
- I go to eject the tape. The front panel buttons is frozen. I
can't use any of the buttons.
-
- I DOUBLE CHECK THE KEY INHIBIT BUTTON, to
make sure I did not accidentally hit it. Nothing wrong, the KEY INHIBIT
IS OFF.
- Remote is disabled.
-
- I check everything, I was the only person
around, Nobody touched my machine 2 minutes earlier. The only way I
can use the Dbeta machine is through a remote. from another machine or
the DS.
-
- Any clues? Has the microprocessor that
controls the front panels bit the dust.
-
- Thanks for any quick information.
-
- Jeff
|
