RE: Live Capture

["Sylvain Labrosse" <slabross(at)Softimage.COM>]

Same as usual...  Stereo output?  24-bit audio instead of 16-bit?  Usually one of those.

Sylvain Labrosse
Avid DS Support
Escalation team

---

From: owner-ds(at)Softimage.COM [mailto:owner-ds(at)Softimage.COM] On Behalf Of Simon Graham
Sent: Thursday, August 25, 2005 1:13 PM
To: DS(at)Softimage.COM
Subject: RE: Live Capture

I also have another question,

Im trying to export a clip as a quicktime with audio,

The image exports as expected but no mater what codec I select there is no audio in the exported clip?

Has something else changed here?

 

Thanks

 

Simon

 

Simon Graham

LIP SYNC POST

LONDON

Tel: +44 (0) 7899 810644

---

From: owner-ds(at)Softimage.COM on behalf of Sylvain Labrosse
Sent: Thu 25/08/2005 17:41
To: DS(at)Softimage.COM
Subject: RE: Live Capture

Live capture has been changed recently (7.5, or was it 7.6?) to support recapture, so yes it has been changed.

 

As with Tape capture, DS is looking at the Source name and Timecode information, not the clip name.  Keeping the same information will cause indeed this problem.

 

So if you capture without a timecode feed (in the remote cable from the deck), Live capture behaves as before and starts its timecode at 00:00:00:00.  The last captured media show for all previous captured clips.

 

Feed timecode and Live capture will register this information and marks each Live captured clip with a different timecode, thus showing the correct media from each clips.

 

And if you accidentally lose this material, you can now recapture, as before it was not possible.  :-))

Sylvain Labrosse
Avid DS Support
Escalation team
http://www.softimage.com/avidds
Check the v7.6 Learning Collection

 

---

From: owner-ds(at)Softimage.COM [mailto:owner-ds(at)Softimage.COM] On Behalf Of Simon Graham
Sent: Thursday, August 25, 2005 11:33 AM
To: DS(at)Softimage.COM
Subject: Live Capture

I was wondering if this has changed in V7 ??

On live capture I set a tape name and capture clips from a non-TC source .

Upon multiple captures DS ascends the name,  but upon viewing the clips the media from one clip has been applied to all clips, as though you have captured different tapes but forgot to change the tape name?

Previously on V6 I could capture from a non-tc source and not change tape names,  the clips would be captured and retained as they were captured.

 

Is this a bug or something that I'm missing.

 

Thanks in advance

 

Simon

 

Simon Graham

LIP SYNC POST

LONDON

Tel: +44 (0) 7899 810644