Scratch the last part of this post. I was
looking at 29.97 TC instead of 24 in the Xpress. The sequence matches the
Nitris sequence perfectly. The only issue is the QT.
----- Original Message -----
Sent: Friday, September 23, 2005 11:52
AM
Subject: 23.98 QT issues
Project is 23.98 edited in MC with downconverted
HDCam. Sequence is about 18 minutes. The offline facility made 23.98
QT (DV/DVCpro Codec) for reference in our Nitris for the conform. The QT
matches up for the first few cuts and progressively goes out as the timeline
progresses. The cuts are 3 frames off, than 6 frames off later in the
timeline and at the end is 23 frames off. The other strange thing is
that, I loaded the 23.98 sequence into our Xpress Pro to check and the
sequence in Xpress Pro ends 6 frames earlier than the sequence that was
brought in to the Nitris. Any ideas?
TIA
KEN
