RE : Not Enough Memory to Complete Operation

["Serge Verreault" <sverreault(at)s29post.com>]

The only workaround is to split your sequence in smaller pieces( I personally don’t like that!) or install V8 on 64 bits that will be fixing all the memory issues!

J

 

-----Message d'origine-----
De : owner-ds(at)Softimage.COM [mailto:owner-ds(at)Softimage.COM] De la part de Ken Sirulnick
Envoyé : November 2, 2005 7:53 AM
À : DS(at)Softimage.COM
Objet : Not Enough Memory to Complete Operation

 

Nitris V7.5 QFE4

1080 23.98psf

110 minute film, lots of rendered effects (sapphire, selective CC, Graphic w/CC).  When I conformed and graded this film, it was broken up into 6 reels.  Now I have 3 seamless versions.  Besides the fact that it takes anywhere from 10 -20 minutes to open a sequence (I know long sequences aren't very happy in DS)  More than occassionally, when I make an adjustment to say a DVE or try to load a clip into the source monitor, I get a "Not Enough Memory To Complete The Operation" message.  Restarting DS usually helps until after a long render.  Then I get the same message.  Any way to get past this? 

 

TIA

 

KEN