I do nit think this case is related to that, it sound more to me like a
limit of being working in a 32 bit environment. Check how much memory the DS
is using at that moment when you have that error. If it is close to the 1.7
GB you will have to reduce the amount of clips or complexity of you
sequence. (at least that is my experience)
Victor Wolansky
DS VFX Artist
WEBsite
Demo Reel
815 Slaters Lane
Alexandria. VA.
443-797-3507
-----Original Message-----
From: owner-ds(at)Softimage.COM [mailto:owner-ds(at)Softimage.COM] On Behalf Of
Andi Loor
Sent: Wednesday, November 02, 2005 12:04 PM
To: DS(at)Softimage.COM
Subject: Re: Not Enough Memory to Complete Operation
I have had a lot of memory problems like that until Sylvain shouted at
me to fix my graphic card settings. It has to be set to DS display.
Hopefully DS runs better now. So it is important that for the memory use
that the display is set right. To be checked at:
rightclick on Desktop, properties, settings, advanced, configuration and
make sure Avid DS is selected in the list.
Andi
(Sylvain did it with good intention)
Troy Thompson wrote:
> Hey Ken,
>
> I get this error on a regular basis. I personally think something
> other than sequence length is going on here (Nitris v. 7.5 QFE4 1080i
> 59.94 6 minute film), and I?ve sent CABs and emails to support.
> Unfortunately, only a restart has gotten me back to work.
>
> Originally it was only happening in HD timelines, but more recently
> has started occurring in SD Sequences as well.
>
> Good luck, let me know if you find something.
>
> Troy
>
>
> *From: *"Ken Sirulnick" <kennitris(at)glueedit.com>
> *Reply-To: *DS(at)Softimage.COM
> *Date: *Wed, 2 Nov 2005 07:52:33 -0500
> *To: *<DS(at)Softimage.COM>
> *Subject: *Not Enough Memory to Complete Operation
>
>
> Nitris V7.5 QFE4
> 1080 23.98psf
> 110 minute film, lots of rendered effects (sapphire, selective CC,
> Graphic w/CC). When I conformed and graded this film, it was
> broken up into 6 reels. Now I have 3 seamless versions. Besides
> the fact that it takes anywhere from 10 -20 minutes to open a
> sequence (I know long sequences aren't very happy in DS) More than
> occassionally, when I make an adjustment to say a DVE or try to
> load a clip into the source monitor, I get a "Not Enough Memory To
> Complete The Operation" message. Restarting DS usually helps until
> after a long render. Then I get the same message. Any way to get
> past this?
>
> TIA
>
> KEN
>
>
--
Andi Loor
www.andiloor.se
---
Subscribe? E-mail Majordomo(at)Softimage.COM with the following text in body:
subscribe ds
Unsubscribe? E-Mail Majordomo(at)Softimage.COM with the following text in body:
unsubscribe ds
---
Subscribe? E-mail Majordomo(at)Softimage.COM with the following text in body: subscribe ds
Unsubscribe? E-Mail Majordomo(at)Softimage.COM with the following text in body: unsubscribe ds
