Re: RE : Not Enough Memory to Complete Operation

[Matthew Small <digital_only(at)earthlink.net>]

We had some memory issues and it helped to change the virtual memory to a disk with more space available.

Until next time...

Matt Small
Pair of Hands
Sherman Oaks, CA

"If it was easy, everyone would do it."


On Nov 2, 2005, at 6:15 AM, Serge Verreault wrote:

> <x-tad-bigger>The only workaround is to split your sequence in smaller pieces( I personally don’t like that!) or install V8 on 64 bits that will be fixing all the memory issues!</x-tad-bigger>
> <x-tad-bigger>J</x-tad-bigger><x-tad-bigger>
> </x-tad-bigger><x-tad-bigger> </x-tad-bigger><x-tad-bigger>
> </x-tad-bigger><x-tad-bigger>-----Message d'origine-----</x-tad-bigger>
> <x-tad-bigger>De :</x-tad-bigger><x-tad-bigger> owner-ds(at)Softimage.COM [mailto:owner-ds(at)Softimage.COM] </x-tad-bigger><x-tad-bigger>De la part de</x-tad-bigger><x-tad-bigger> Ken Sirulnick</x-tad-bigger>
> <x-tad-bigger>Envoyé :</x-tad-bigger><x-tad-bigger> November 2, 2005 7:53 AM</x-tad-bigger>
> <x-tad-bigger>À :</x-tad-bigger><x-tad-bigger> DS(at)Softimage.COM</x-tad-bigger>
> <x-tad-bigger>Objet :</x-tad-bigger><x-tad-bigger> Not Enough Memory to Complete Operation</x-tad-bigger>
>  
> <x-tad-bigger>Nitris V7.5 QFE4</x-tad-bigger>
> <x-tad-bigger>1080 23.98psf</x-tad-bigger>
> <x-tad-bigger>110 minute film, lots of rendered effects (sapphire, selective CC, Graphic w/CC).  When I conformed and graded this film, it was broken up into 6 reels.  Now I have 3 seamless versions.  Besides the fact that it takes anywhere from 10 -20 minutes to open a sequence (I know long sequences aren't very happy in DS)  More than occassionally, when I make an adjustment to say a DVE or try to load a clip into the source monitor, I get a "Not Enough Memory To Complete The Operation" message.  Restarting DS usually helps until after a long render.  Then I get the same message.  Any way to get past this? </x-tad-bigger>
>  
> <x-tad-bigger>TIA</x-tad-bigger>
>  
> <x-tad-bigger>KEN</x-tad-bigger>