Or cycle your animation curves which will repeat the animation forever.
Easier for what your trying to do than building and testing expressions.
_spencer
On Monday, Dec 5, 2005, at 15:56 America/Los_Angeles, Benoit Lauzon
wrote:
Hi Jon
Unfortunately expressions are not supported in graphics.
However, for that particular effect, you could create your artwork
with RGBA graphics
over a black transparent clip, slap a dissolve on top of that and
drive it's amount value
(of the dissolve, that is) through expressions.
This can be achieved using filters or tree nodes, as you see fit.
Hope this helps,
Ben
-----Original Message-----
From: owner-ds(at)Softimage.COM [mailto:owner-ds(at)Softimage.COM]On Behalf
Of
Jon Vargo
Posted At: Monday, December 05, 2005 6:42 PM
Posted To: ds
Conversation: flashing text
Subject: flashing text
hey everyone,
I have a newbie question about animating text. I need to create a
flashing red dot and rec to simulate looking through a viewfinder of a
camera. My initial though is to create those elements in the graphics
layout and then animate the opacity.
Is there a way to create an expression for the graphics elements or am
I stuck hand key framing this? Or is there a better way to approach
this?
thanks
Jon Vargo
Video Arts SF
---
Subscribe? E-mail Majordomo(at)Softimage.COM with the following text in
body: subscribe ds
Unsubscribe? E-Mail Majordomo(at)Softimage.COM with the following text in
body: unsubscribe ds
---
Subscribe? E-mail Majordomo(at)Softimage.COM with the following text in
body: subscribe ds
Unsubscribe? E-Mail Majordomo(at)Softimage.COM with the following text in
body: unsubscribe ds
---
Subscribe? E-mail Majordomo(at)Softimage.COM with the following text in body: subscribe ds
Unsubscribe? E-Mail Majordomo(at)Softimage.COM with the following text in body: unsubscribe ds
