|
Also check that the dummy CRRM memory boards are in place and
seated properly and the the entire memory subassembly board is well
seated.
Howard
From: owner-ds(at)Softimage.COM
[mailto:owner-ds(at)Softimage.COM] On Behalf Of Russ Grycza
Sent:
Tuesday, December 20, 2005 11:22 AM
To:
DS(at)Softimage.COM
Subject: Compaq W8000 memory
error
Hi all -
Our DS 6.0 system on a Compaq W8000 has gotten this
annoying habit of late of crashing out to a blue screen (with no warning, I
might add) with the following error message:
Hardware malfunction. Call your hardware vendor for
support.
NMI: Parity check/memory parity error.
*The system has halted*
Obviously it must have some RAM that's going bad,
but is there anyway to isolate which one it may be, or do I have to replace the
whole 1.5 gig?
Thanks!
Russ
| 
