Rightclick the clip in explorer and choose properties. Here you will be
able to edit the in and outpoints of the clip. Then you will have to
replace the clip on the timeline with the edited version from the
explorer. The clip will not let you edit it if it is in the source
viewer at the same time. If so then clear the source viewer first.
Laborious yes, but possible.
Andi
John McMullin wrote:
Hello there.
I have a shot in a sequence that I want to trim out, but it doesn't have long enough handles. I can "recapture with options" and choose say 50 frames. This will have me 100 frames more media but I still have no way to trim out the shot because my master clip still has the same start and end points. Is the only way to correct this to "log" a new shot and then cut it into the sequence where I want it? This seems a pretty laborious way round.
Thanks for any better ideas.
John
Disclaimer -
23/12/2005 This email and any files transmitted with it are confidential and intended solely for
ds(at)softimage.com at ds(at)softimage.com. If you are not the named addressee you should not
disseminate, distribute, copy or alter this email. Any views or opinions presented in this
email are solely those of the author and might not represent those of VET.
Warning: Although VET has taken reasonable precautions to ensure no viruses are present
in this email, the company cannot accept responsibility for any loss or damage arising from
the use of this email or attachments.
---
Subscribe? E-mail Majordomo(at)Softimage.COM with the following text in body: subscribe ds
Unsubscribe? E-Mail Majordomo(at)Softimage.COM with the following text in body: unsubscribe ds
--
Andi Loor
www.andiloor.se
---
Subscribe? E-mail Majordomo(at)Softimage.COM with the following text in body: subscribe ds
Unsubscribe? E-Mail Majordomo(at)Softimage.COM with the following text in body: unsubscribe ds
