RE: Writing and reading .fraw2 via scripting?

["Andy Nicholas" <andy(at)andynicholas.com>]

I don't know if there's a command specifically to do it, but it's easy
enough to do by hand. 

I wrote this script a while back to print the camera motion as an .fraw2
when I was trying to get Digital Fusion to import the camera motion from
XSI. It doesn't show the keyframe constraints, but that shouldn't be too
hard to add.

Anyway, I've pasted it below for you. Hope it helps.


'---------------------------------------------------

set obj = Selection(0)
set animParams = obj.kinematics.local.animatedparameters

dim rootName
rootName = obj.kinematics.local.fullname
rootLen = Len(rootName)

'Need to replace this bit with a scene lookup for the FPS
dim fps
fps=1/25

for each param in animParams
	dim paramName
	paramName = right(param.fullname,Len(param.fullname)-rootLen-1)
	logmessage "Start_FCurve "&paramName
	set keyList = param.source.keys
	
	for each key in keyList
		dim v1,v2,v3,v4,v5,v6
		v1=FormatNumber(key.time*fps,6)
		v2=FormatNumber(key.value,6)
		v3=FormatNumber(key.righttanx*fps,6)
		v4=FormatNumber(key.righttany*fps,6)
		v5=FormatNumber(key.lefttanx*fps,6)
		v6=FormatNumber(key.lefttany*fps,6)
		logmessage  "0 "&v1&" "&v2&" "&v3&" "&v4&" "&v5&" "&v6&" 388
3"
	next
	
	logmessage "End_FCurve"	
next





-----Original Message-----
From: owner-xsi(at)Softimage.COM [mailto:owner-xsi(at)Softimage.COM] On Behalf Of
Jeff McFall
Sent: 08 July 2005 20:32
To: XSI(at)Softimage.COM
Subject: Writing and reading .fraw2 via scripting?

Is it possible to output (and input) .fraw2 files via scripting?
Specifically VBS

Can't seem to find any reference in the scripting manuals and don't get any
feedback from the script editor when messing in the fcurve editor.






Jeff McFall
Video Communications & New Media
919 531 4775
jeff.mcfall(at)sas.com

> SAS...The Power to Know
> 

---
Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
unsubscribe xsi


---
Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
unsubscribe xsi