|
Ouch!
From: Ian Stewart
Sent: Friday,
October 28, 2005 4:41 PM
To: 'XSI(at)Softimage.COM'
Cc: Éric
Cabot
Subject: RE: knife tool
(I
will go pat Éric on the back for you)
-----Original Message-----
From: owner-xsi(at)Softimage.COM
[mailto:owner-xsi(at)Softimage.COM]On Behalf Of Ian Stewart
Posted
At: October 28, 2005 4:37 PM
Posted To:
xsi
Conversation: knife tool
Subject: RE: knife
tool
Select
some polygons
Start
the knife tool with [
Cut
-----Original Message-----
From: owner-xsi(at)Softimage.COM
[mailto:owner-xsi(at)Softimage.COM]On Behalf Of Wayne Williams
Posted
At: October 28, 2005 4:23 PM
Posted To:
xsi
Conversation: knife tool
Subject: knife
tool
Is there any way to get the knife tool to cut only
a selected set of polygons/edges.......instead of slashing my model from head to
toe? I really dig using it because it slices the edges leaving a perfectly
straight cut....using the shft+d hotkey doesnt always result in the same
cleaness of lines. I can't use the knife most of the time due to it
shooting the slice allllll the way through the model instead of just where i
want it. Is there another tool I've overlooked that does what I'm
wanting?
| 
