Rainer Schmidt wrote:
>
> I ran into a problem with the spiral which I am unable to resolve....
>
> 1. create a spiral 0-1440 degree.
> 2. create a square.
> 3. Create Polymesh, extrude along curve.
>
> Square was selected, curve got picked. Now the extrusion follows. BUT
> the square is slowly rolling around the center of the curve.
> HOW can I prevent that it rolls during extrusion. I need a square
> channel where the square itself does not rotate. Like a spiral
> staircase, the steps do not warp ot tilt either on the way down.
>
> sighhhhh any ideas? I'm stuck...
> ---
> Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
> unsubscribe xsi
In your Extrusion dialog, turn Rotate Profile and Align Profile to Path
off. Does that help?
--
Joey Ponthieux
NCI Information Systems Inc.
NASA Langley Research Center
____________________________________________________________
Opinions stated here-in are strictly those of the author and
do not represent the opinions of NASA or any other party.
---
Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
unsubscribe xsi
