Been there unfortunately
If I remember correctly we got out of this by duplicating the curve (profile) along the path multiple times
Then use "loft" to join them
-----Original Message-----
From: owner-xsi(at)Softimage.COM [mailto:owner-xsi(at)Softimage.COM] On Behalf Of Rainer Schmidt
Sent: Monday, October 31, 2005 1:39 PM
To: XSI(at)Softimage.COM
Subject: Spiral of Hell
I ran into a problem with the spiral which I am unable to resolve....
1. create a spiral 0-1440 degree.
2. create a square.
3. Create Polymesh, extrude along curve.
Square was selected, curve got picked. Now the extrusion follows. BUT the square is slowly rolling around the center of the curve.
HOW can I prevent that it rolls during extrusion. I need a square channel where the square itself does not rotate. Like a spiral staircase, the steps do not warp ot tilt either on the way down.
sighhhhh any ideas? I'm stuck...
---
Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
unsubscribe xsi
---
Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
unsubscribe xsi
