The curve rolls... that's the problem. But I found 'a' solution with the
animation and loft tools.
Gene Crucean wrote:
It's hare to say without knowing exactly what you want. But maybe
uncheck Perpendicular (align Y to curve tangents)?
Do you have an image that shows what your going for?
On 10/31/05, *Rainer Schmidt* <itrisk(at)gmx.net <mailto:itrisk(at)gmx.net>>
wrote:
I ran into a problem with the spiral which I am unable to resolve....
1. create a spiral 0-1440 degree.
2. create a square.
3. Create Polymesh, extrude along curve.
Square was selected, curve got picked. Now the extrusion follows. BUT
the square is slowly rolling around the center of the curve.
HOW can I prevent that it rolls during extrusion. I need a square
channel where the square itself does not rotate. Like a spiral
staircase, the steps do not warp ot tilt either on the way down.
sighhhhh any ideas? I'm stuck...
---
Unsubscribe? Mail Majordomo(at)Softimage.COM
<mailto:Majordomo(at)Softimage.COM> with the following text in body:
unsubscribe xsi
--
-gc
---
Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
unsubscribe xsi
