|
Hehe yeah I saw that. Sounds like a decent workaround. My messages take forever to make it through for some reason.
Take care
On 10/31/05, Rainer Schmidt <itrisk(at)gmx.net> wrote:
The curve rolls... that's the problem. But I found 'a' solution with the
animation and loft tools.
Gene Crucean wrote:
> It's hare to say without knowing exactly what you want. But maybe
> uncheck Perpendicular (align Y to curve tangents)?
>
> Do you have an image that shows what your going for?
>
>
>
> On 10/31/05, *Rainer Schmidt* <itrisk(at)gmx.net <mailto:
itrisk(at)gmx.net>>
> wrote:
>
> I ran into a problem with the spiral which I am unable to resolve....
>
> 1. create a spiral 0-1440 degree.
> 2. create a square.
> 3. Create Polymesh, extrude along curve.
>
> Square was selected, curve got picked. Now the extrusion follows. BUT
> the square is slowly rolling around the center of the curve.
> HOW can I prevent that it rolls during extrusion. I need a square
> channel where the square itself does not rotate. Like a spiral
> staircase, the steps do not warp ot tilt either on the way down.
>
> sighhhhh any ideas? I'm stuck...
> ---
> Unsubscribe? Mail Majordomo(at)Softimage.COM
> <mailto:Majordomo(at)Softimage.COM> with the following text in body:
> unsubscribe xsi
>
>
>
>
> --
> -gc
---
Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
unsubscribe xsi
--
-gc
|
