I have a model with some points that I'd like to
connect an edge on a per pair of point basis.
ex.
. .
<---- a pair of points....i select them and then wish to
"connect" them ala wings/max etc. Basically you select two points and hit
connect and the result would be as follows.
.-----.
I know that I can just use the add edge tool but when i have a ton of them
to do it gets rather tedious and kills the workflow when I could just select
some points and hit connect and the edge is shot across the points nearest each
other. There is a workaround in some situations using the bridge boundary edges
op but sometimes not even that will work. Will this "connect" functionality be
added in the future maybe? Thanks!
-wayne-
