Hello Wayne, no it's not that. But I did notice that for some reason
the "Y" axis is the only axis on when I use this tool. Odd I can't
turn on all 3.
Christopher
Sunday, May 14, 2006, 11:16:43 PM, you wrote:
> Perhaps you have the slide along normal toggled on? It's the little magnet
> icon down at the bottom there.
> -----Original Message-----
> From: owner-xsi(at)Softimage.COM [mailto:owner-xsi(at)Softimage.COM] On Behalf Of
> Chris
> Sent: Sunday, May 14, 2006 10:05 PM
> To: Wayne
> Subject: Re[4]: 1 licence for two different versions -> I GOT IT WORKIN
> Ohhh, thanx wayne. One other thing I'd like the
> move-point tool to work in all axis currently it's like it's
> restricted to one axis YET all 3 axis are selected in the MCP panel.
> Christopher
> Sunday, May 14, 2006, 9:51:01 PM, you wrote:
>> Hit M, turn on prop, click and hold R and click drag <left or >right
>> -----Original Message-----
>> From: owner-xsi(at)Softimage.COM [mailto:owner-xsi(at)Softimage.COM] On Behalf
> Of
>> Chris
>> Sent: Sunday, May 14, 2006 7:33 PM
>> To: Bernard Lebel
>> Subject: Re[2]: 1 licence for two different versions -> I GOT IT WORKIN
>> You know though so far so good, with going to 5.o there are things
>> that acctully would help me in my workflow. There is one thing though
>> that I have a beef over the move point tool, how come I can't adjust
>> it's radius with a shortcut key (like say "R") I have to manually go
>> into and adjust the radius.
>> Christopher
>> walkfar media
>> Sunday, May 14, 2006, 6:26:27 PM, you wrote:
>>> Sooooooo???? What was the problem afterall? How did you make it work?
>>> On 5/14/06, Chris <walksfar(at)netscape.ca> wrote:
>>>> I GOT IT WORKING.
>>>>
>>>> I would like to thank everyone though for helping me, kim, bernard,
>>>> wayne, stephen, will, if I didn't name you don't feel left out.
>>>>
>>>> Christopher
>>>>
>>>>
>>>>
>>>> ---
>>>> Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in
>> body:
>>>> unsubscribe xsi
>>>>
>>> ---
>>> Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in
> body:
>>> unsubscribe xsi
--
Best regards,
Chris mailto:walksfar(at)netscape.ca
---
Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
unsubscribe xsi
