Just to let you know: messages with multiple answers may not yield as
much answers as separate threads...... especially if they need
elaborate discussion.
I usually answer only a fraction of such messages.
Bernard
On 5/14/06, Wayne <w1343(at)comcast.net> wrote:
A suggestion would be to go to
http://www.3m.com/us/office/postit/digital/ and install that.
Then type in the questions you think of throughout the day. At the end of
the day just shoot a mail off with your compilation.
-----Original Message-----
From: owner-xsi(at)Softimage.COM [mailto:owner-xsi(at)Softimage.COM] On Behalf Of
Chris
Sent: Sunday, May 14, 2006 10:12 PM
To: XSI(at)Softimage.COM
Subject: Merge in 5.1
I don't know if this has been covered but in 4.2 when I merged meshs,
I could just freeze in the operator and the previous mesh is gone.
Now in 5.1 it keeps the two there, sure it is handy incase but is
there a way I can toggle this on or off? And if I recall a previous
post on 5.1 and the IMED mode something to do with when modelling in
5.x it keeps it on, does someone want to refresh my memory or should
I just not worry about this ?
Christopher
---
Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
unsubscribe xsi
---
Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
unsubscribe xsi
---
Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
unsubscribe xsi
