maybe i am missing something here...
i track the problem down to the delta.
i updated the reference model on the disc but in the actual master
scene i dont see any changes i did inside the mixer (i replaced the
cycled clip+clipeffect with a frozen version).
when i switch off the mixer in the delta options, and reload the
master scene i DO see the new model loaded correctly from disc in.
however, all my other animations (i placed the model from time to
time somwhere else to fake more characters) that existed on some
dummies are gone. the delta STILL lists the fcurves and positions with
actual values, but they dont have any effect any more.
its like i switched off everything the delta should remember, not just
the mixer options.
anybody experienced this??? i am slowly out of options.....
ciao
franky
Wednesday, May 30, 2007, 8:51:43 PM, you wrote:
FL> Hello,
FL> i pulled my last hair over this.
FL> i got a scene with about 50 reference models (characters) that are
FL> walking around, digging and do some general construction work.
FL> some of the walk and the walks are cycled and using the CID variable
FL> clip effect to make them walk forward over the cycles.
FL> so far so good.
FL> BUT
FL> after i saved the scene couple times and then reload, the clip effects
FL> are gone! bumm...
FL> the reference models that are on disc DO have the clip effects. just
FL> the loaded ones in my master scene forget them (the master scene is
FL> about 250mb by now, which i think is quite big for for almost only ref
FL> models loaded in)
FL> when i correct the behaviour and set ALL the clip effects again, save
FL> and load the scene everything seems fine.
FL> i just found out about it again when i sent it to rendering. the clip
FL> effects are gone again.
FL> this is 6.01 btw and the delta records the mixer stuff of course.
FL> however, it should load by default the proper mixer.
FL>
FL> ciao
FL> franky
FL> ---
FL> Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
FL> unsubscribe xsi
---
Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
unsubscribe xsi
