Hey André, thanks a lot for the explanation.
But I'm affraid we're not even there. I have two tracks with a clip.
The weight parameters have..... *two* keyframes (spline
interpolation), it's simple blend between the two clips.
Bernard
On 9/4/07, André Adam <a_adam(at)49games.de> wrote:
> The red curves shown on top of mixer clips either have a fixed number of
> CVs or there is a total CVs limit to them, I don't remember that one
> exactly, it was something along these lines. Basically that means when
> you have complex weight curves, the display is only correct in the
> FCurve Editor, not in the mixer panel. I reported that one to Softimage
> one or two years back, but they didn't do something about it up to now.
> Go ahead and complain at support, perhaps that raises this issue on
> their priority list a bit...
>
> Cheers!
>
> -André
>
>
> Bernard Lebel wrote:
> > As far as I can tell it looks correct.
> >
> > Bernard
> >
> >
> >
> > On 8/31/07, bilkaxsi <bilkaxsi(at)gmail.com> wrote:
> >
> >> how is your tangent of the weight fcurve ?
> >>
> >> regards
> >>
> >> bilka
> >>
> >>
> >>
> >>>
> >>> 2007/8/28, Bernard Lebel <3dbernard(at)gmail.com>:
> >>>
> >>>
> >>>> Hello,
> >>>>
> >>>> I'm adding fcurves to some mixer clips. For instance I put these
> >>>>
> >> keyframes:
> >>
> >>>> frame 1 -> 0%
> >>>> frame 10 -> 100%
> >>>>
> >>>> When I inspect the fcurve in the animation editor, it's all fine. The
> >>>> right side slider is also displaying the right values at the right
> >>>> time.
> >>>>
> >>>> But the red line over the clip is absolutely off. It's displaying
> >>>> those values, roughly:
> >>>>
> >>>> frame 1 -> 0%
> >>>> frame 2.25 -> 100%
> >>>>
> >>>>
> >>>> Am I missing something?
> >>>>
> >>>>
> >>>> Thanks
> >>>> Bernard
> >>>> ---
> >>>>
>
> ---
> Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
> unsubscribe xsi
>
---
Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
unsubscribe xsi
