Ok, that's a differrent story then... good luck with that one!
-André
Bernard Lebel wrote:
Hey André, thanks a lot for the explanation.
But I'm affraid we're not even there. I have two tracks with a clip.
The weight parameters have..... *two* keyframes (spline
interpolation), it's simple blend between the two clips.
Bernard
On 9/4/07, André Adam <a_adam(at)49games.de> wrote:
The red curves shown on top of mixer clips either have a fixed number of
CVs or there is a total CVs limit to them, I don't remember that one
exactly, it was something along these lines. Basically that means when
you have complex weight curves, the display is only correct in the
FCurve Editor, not in the mixer panel. I reported that one to Softimage
one or two years back, but they didn't do something about it up to now.
Go ahead and complain at support, perhaps that raises this issue on
their priority list a bit...
Cheers!
-André
Bernard Lebel wrote:
As far as I can tell it looks correct.
Bernard
On 8/31/07, bilkaxsi <bilkaxsi(at)gmail.com> wrote:
how is your tangent of the weight fcurve ?
regards
bilka
2007/8/28, Bernard Lebel <3dbernard(at)gmail.com>:
Hello,
I'm adding fcurves to some mixer clips. For instance I put these
keyframes:
frame 1 -> 0%
frame 10 -> 100%
When I inspect the fcurve in the animation editor, it's all fine. The
right side slider is also displaying the right values at the right
time.
But the red line over the clip is absolutely off. It's displaying
those values, roughly:
frame 1 -> 0%
frame 2.25 -> 100%
Am I missing something?
Thanks
Bernard
---
---
Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
unsubscribe xsi
---
Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
unsubscribe xsi
---
Unsubscribe? Mail Majordomo(at)Softimage.COM with the following text in body:
unsubscribe xsi
