|
Yes - the point is I need to model a lot of
branches with shapes defined by me, which is why I dont go for a plant modeling
tool. So it will save me quite some time not having to do cylinders, taper,
deform and fit.
MB
----- Original Message -----
Sent: Thursday, September 06, 2007 6:56
PM
Subject: Re: Extrusion question
I normally extrude my object and taper it and then deform to
curve. But I'm guessing you were trying to avoid that step.
On 9/6/07, Morten
Bartholdy <xsi(at)colorshopvfx.dk> wrote:
That is exactly what I was looking for, but no
go.
MB
-----
Original Message -----
Sent:
Thursday, September 06, 2007 3:19 PM
Subject:
Re: Extrusion question
At 13:54 06.09.2007, you wrote:
Do any of you know if there is a way to taper
the radius of a circle extruded along a curve using the extrusion
tool?
I know there are workarounds but they require more manual work,
so if there is a way to set start and end radius it would just be
great.
Can't check right now, but don't you have the
option to SRT the circle along the extrusion? Just scale the circle
down...
Cheers, Dave
David Auner
Filmproduktion
Assmayergasse
5-7/1/1
A-1120 Wien
Austria
phone +43 664 11 27 481
e-mail
david(at)auner.net
www http://www.auner.net
uid
nr./vat no. ATU57818455
---<<| "I am eye. I am a
mechanical eye. |>>---
---<<|
I, a machine, am showing you a world, |>>---
---<<|
the likes of which only I can see."
|>>---
---<<| - Dziga
Vertov
|>>---
--
Byron Nash
www.armoredsquirrel.com
|
